Installation Instructions
10”
6
-1/8"
5
-1/4"
6
-1/2"
2
-3/8"
2
-3/8
9
-3/4"
3”
2
3
/
8
” dia
1
-1/4"
10”
6
-1/8"
5
-1/4"
6
-1/2"
2
-3/8"
2
-3/8"
9
-3/4"
3”
2
3
/
8
” dia
1
-1/4"
Adjustable
wrench
Channel
locks
Plumbers’ putty
or caulking
Flat head
screwdriver
Cross head
screwdriver
Hexagonal
key
Belgravia Deck-mount Tub Faucet
with Handshower
U
S-BL440
Introduction
Installation notes
The faucets in this range are single flow (hot and cold water mix in the
body) and should therefore be supplied with hot and cold water at
balanced pressures. If the faucets are not supplied at balanced
pressures then the mixer will not function correctly.
The minimum water pressure required for these faucets is
1.45
psi. The
maximum water pressure is
72.5
psi, (beyond which pressure reducing
valves must be
installed
).
The faucets are fitted with quarter
-
turn ceramic disc cartridges which
provide a good flow rate with very smooth movement.
IMPORTANT:
Before beginning installation, check for any damage
that may have occurred during transport.
Note: Damage claims cannot be made during or after installation.
Please read these instructions carefully before begin
ning
and
retain for future reference. These instructions have been
prepared for your guidance, you must exercise due care at all
times. We do not accept responsibility for any problems that may
occur through incorrect installation.
Dimensions
Tools required
The installation must comply with all plumbing codes including local
codes and be installed by a licensed plumbing contractor.
Anti-scald protection is the responsibility of the installer and
according to applicable codes.
IMPORTANT
!
Before installing a new faucet it is essential that
the
supply pipes are thoroughly flushed
in order to remove any remaining
debris
, solder or other impurities. Failure to carry out this simple
procedure can cause problems or damage to the working of the
faucet.
Installing shut-off valves on incoming supply lines is recommended
for ease of maintenance.
T
urn off the main water supply before connecting to any existing
pipework or doing any maintenance.
WARNING! Please check for any hidden pipes and cables, electric
or otherwise
,
before drilling holes
in wall or floor
.