Crosswater Belgravia US-BL130 Installation Instructions Download Page 1

Installation Instructions

1”

4

-1/2"

5

-1/4"

4

-1/2"

1

/

2

”  NPSM

2

-3/8"

2”

1” 

1”

4

-1/2"

5

-1/4"

4

-1/2"

1

/

2

”  NPSM

2

-3/8"

2” 

1” 

Adjustable

wrench

Channel

locks

Plumbers’ putty

or caulking

Flat head

screwdriver

Cross head

screwdriver

Hexagonal

key

Belgravia Widespread Basin Faucet

US-BL130

Introduction

Installation notes

The faucets in this range are single flow (hot and cold water mix in the 

body) and should therefore be supplied with hot and cold water at 

balanced pressures. If the faucets are not supplied at balanced 

pressures then the mixer will not function correctly.
The  minimum  water  pressure  required  for  these  faucets  is 

1.45

  psi. 

The  maximum  water  pressure  is 

72.5

  psi

 

beyond  which  pressure

-

reducing valves must be 

installed

.

The faucets are fitted with quarter

-

turn ceramic disc cartridges which 

provide a good flow rate with very smooth movement.

Before beginning installation, please check for any damage that may 

have occurred during transport. 

Note: Damage Claims cannot be 

made during or after installation.

IMPORTANT: Please read these instructions carefully before you 

begin and retain for future reference. These instructions have 

been prepared for your guidance, you must exercise due care at 

all times. 
We do not accept responsibility for any problems that may occur 

through incorrect installation.

Dimensions

Tools required

The installation must comply with all plumbing codes including local 

codes and be installed by a licensed plumbing contractor. 

WARNING!

 Before installing a new faucet it is essential that the supply 

pipes are thoroughly flushed in order to remove any remaining debris, 

solder or other impurities. Failure to carry out this simple procedure 

can cause problems or damage to the working of the faucet.

Installing shut-off valves on incoming supply lines is recommended 
for ease of maintenance. 

T

urn off the main water supply before connecting to any existing 

pipework or doing any maintenance.
WARNING! Please check for any hidden pipes and cables, electric 

or otherwise

,

 before drilling holes in a wall

 or floor

.

Reviews: