EL-4K-VIP-ACM
QUICK REFERENCE GUIDE
Panel Description
Default IP Address of Control & Video RJ45 Ports
The ELAN EL-4K-VIP-ACM is shipped with the following default IP address for the Control Port (connected to your main network) and Video Port
(connected to your VIP system network):
Control Port Default IP Address:
DHCP
Video Port Default IP Address:
169.254.2.225
After connecting to the main network, use the ELAN configurator to discover and set a static IP address. After which you can configure the system
right from the configurator or use the web interface at the now set IP address.
Default login details:
Username
:
ELAN
Password
:
3526
NOTE:
The default IP address of the video port should not be changed as it is specifically configured to work with ELAN VIP TX/RX products.
For further details please see the full product manual available to download at
www.elanhomesystems.com
.
EL-4K-VIP-ACM
Quick Reference Guide
Introduction
The ELAN Premium Video over IP (VoIP) platform distributes HDMI video over a 1GB Network switch using visually lossless technology. The EL-4K-
VIP-ACM can be completely configured directly from the ELAN configurator, or the web interface can be used for configuration and independent
routing of IR, RS-232, USB / KVM, Audio, and Video. ELAN drivers built into each product’s firmware simplify product installation and negate the
need for an understanding of complex network infrastructures. The EL-4K-VIP-ACM Advanced Control Module is designed to work with the ELAN
Home System and also features third-party control using TCP / IP, RS-232 and IR.
1
RS-232 control port – Connect to a third party control device for
control of the VIP system using RS-232.
2
MCU firmware update switch - Used to place ACM product into
firmware update mode
3
Reset - Short press resets the EL-4K-VIP-ACM, long press (10
seconds) factory defaults the EL-4K-VIP-ACM
4
IO Level switch - Reserved for future use
5
IO Level Phoenix - Reserved for future use.
6
Video LAN (PoE) - Connect to the network switch that the ELAN
VIP components are connected to
7
Control LAN port - Connect to existing network that a third party
control system resides on. The Control LAN port is used for TCP/
IP control of the VIP system. This port does not support PoE
8
IR Control (IR input) – 3.5mm stereo jack. Connect to third party
control system if using IR as the chosen method of controlling
the Multicast system. When using the included 3.5mm stereo to
mono cable, ensure the cable direction is correct
9
IR - Adjust IR voltage level between 5V or 12V input for IR Control
q
Power LED indicator - Solid status light when the unit is receiving
power
w
Power port – Use 12V 1A DC adaptor (sold separately) if not using
a PoE network switch
EL-4K-VIP-ACM - Front Panel
2
1
4
3
9
8
7
6
EL-4K-VIP-ACM - Rear Panel
11
10
5
10023303_RevA4_Quick_Reference_Guide_ELAN_EL-4K-VIP-ACM_0404.indd 1
04/04/2019 14:12
