Operation Instructions
17
/
55
Chapter 5: Operation Instructions
—————————————————————————————————
5.1 Turning on device
A) Open the circuit breaker(at the rear of the device) to the ON position. Then turn the cam switch to the
ON position to allow power supply access to the device.
5.2 Connecting to computer
Refer to 4.6.7, connect the computer USB port
5.3 Laboo-HDI installation & startup
5.3.1Connecting the Dongle and install LaBoo-HDI software
a) Remove the supplied dongle from the LaBoo software box and plug it into the USB port of the
computer;
b) Inserts theLaBoo software installation disk(provided in the Laboo software box) and insert it into
your computer's CD-ROM drive and run the "HDI Setup.exe" file;
c) Follows the software installation steps to install the LaBoosoftware and dongle driver.After
installation is completed successfully, the computer desktop will have the following icon shown as
below:
