background image

 

 

 
 
 
 
 
 
 
 

 

 

          

 

 

 

INSTALLATION INSTRUCTIONS: 

 
The

 

SV-6911.IR is a hanging style Rear View Camera with Night Vision. It can be mounted up 

high on the back up the vehicle which makes it perfect for bigger vehicles such as Semi Trucks, 
Motor  Homes,  Trailers, and  Vans.    It  can  also  be  mounted  down low  on  the  vehicle, either  on 
the bumper or under a license plate bezel if there is adequate space. 

 

 
FEATURES: 

 

  Hanging style CMOS color camera 

  120° Viewing Angle 

  Equipped with Infra Red LED for Night Vision 

  Can be mounted high or low on the vehicle depending on owner’s preference 

  Optional Audio Input. Perfect for hooking up to a DVR system 

  Perfect for Semi Trucks, Motor Homes, Buses, or Vans 

  Normal Image built-in 

  Durable Zinc Alloy Die Cast Body 

  Swiveling lens shield to keep excess light out of camera lens 

  Provides extra security when backing-up 

  Waterproof Camera Design (IP68) 

 

SV- 6911.IR 

Hanging Style Rear View 

Camera with Night Vision 

 

Summary of Contents for SecurView SV-6911.IR

Page 1: ...s adequate space FEATURES Hanging style CMOS color camera 120 Viewing Angle Equipped with Infra Red LED for Night Vision Can be mounted high or low on the vehicle depending on owner s preference Optional Audio Input Perfect for hooking up to a DVR system Perfect for Semi Trucks Motor Homes Buses or Vans Normal Image built in Durable Zinc Alloy Die Cast Body Swiveling lens shield to keep excess lig...

Page 2: ... check behind your drilling location for clearance 4 Locate a suitable place to drill a hole to route the camera wiring harness into the vehicle 5 Route the harness through the hole Seal the hole the rubber grommet provided on the camera wiring harness Squeeze the grommet tightly into the hole so that no water can leak through 6 Reassemble the Camera and Lens Shield to the Mounting Bracket SIDE VI...

Page 3: ...er at the rear of the vehicle behind the reverse lights You may also connect power inside the vehicle under the dash or in the trunk The Red power wire goes to Reverse Light 12V and the Black wire to Ground 4 Run the Yellow RCA video cable to your monitor s video input or reverse camera input The White RCA cable is for audio and will not need to hooked up unless you are using a DVR system in the v...

Page 4: ...ck and verify any and all State or Federal Motor vehicle codes with regards to modifications of the vehicle www crimestopper com email crimestopper com Phone 800 998 6880 FAX 805 581 9500 2009 Crimestopper Security Products REV A 4 29 2009 SPECIFICATIONS 1 4 Color CMOS Sensor Video Output 1 0 V P P composite 75 Ohm load Dimension 2 5 8 W 1 5 8 H 2 D Supply Voltage 12VDC Weight 12 Oz Power Consumpt...

Reviews: