Crestron
WPR-DS
Docking Station for WPR-48
Power Pack Specifications
CRESTRON POWER
PACK
INPUT SPECS
OUTPUT SPECS
PW-1205
120 VAC, 60 Hz
12 VDC, 0.5 A
PWI-1210
230 VAC, 50 Hz, 110 ma
12 VDC, 1.0 A, 12 VA
Power Pack Polarity
Docking Station to PC Serial Communication
Use an RS-232 cable (RJ-11 – DB-9, such as the Crestron STCP-502 (not supplied)
to connect the WPR-DS to the serial port of the PC. This connection can also be
made with a modular RJ-11 cable and a DB9F to RJ-11 adapter. (Refer to the
following illustration.)
CONNECTOR,
6 PIN, RJ-11
(TAB FACING
AWAY)
STCP-502 PINOUT
CONNECTOR,
DB9, FEMALE
(REAR VIEW)
Pin 1
SIGNAL
DB9
PINS
RJ-11
PINS
3
4
5
2
8
7
6
1
CTS
5
3
2
G
Rx
Tx
RTS
n/c
5
3
1
2
4
9
8
6
7
Problem Solving
Troubleshooting
The table below provides corrective action for possible trouble situations. If further
assistance is required, please contact a Crestron customer service representative.
WPR-DS Troubleshooting
TROUBLE
POSSIBLE
CAUSE(S)
CORRECTIVE ACTION
Green power LED
(Swirl Logo) does not
illuminate.
WPR-DS is not
receiving power.
Confirm that power pack is
plugged into outlet, and connector
is plugged into the WPR-DS
power input port.
Power pack not
functioning
Verify output (12 VDC minimum).
Replace power pack if necessary.
Power LED
illuminates, but battery
does not charge.
Incorrect power
pack being
used.
Verify that the power pack is
correct - PW-1205 (120 VAC) or
PWI-1210 (230 VAC).
Operations Guide – DOC. 6255A
Docking Station for WPR-48: WPR-DS
•
5
