DO
GUIDE
DO
Check the Box
QTY
PART NUM.
1
TSW-UMB Universal Mounting Bracket
4517962
1
Pre-Construction Bracket
2035648
TSW-552
5" Touch Screen
DO
Install the Device
The TSW-552 can be mounted into drywall and other surfaces
or mounted onto a wall stud. When mounted into drywall and
other surfaces, the touch screen protrudes just 1/2” (13 mm)
from the mounting surface.
To mount the TSW-552, use the following procedure:
1. For pre-construction applications, use standard drywall
nails or screws to attach the included pre-construction
bracket to a wall stud.
Pre-Construction Bracket Attached to a Wall Stud
CAUTION:
Allow an air gap of at least 12” (305 mm) in
the wall cavity above and below the TSW-552 for heat
dissipation.
For post-construction applications, use the
pre-construction bracket as a cutout template by turning
the bracket to face the wall, ensuring it is level, and
temporarily tacking it to the wall with finishing nails (not
included) in the smaller holes around the cutout opening.
Trace the cutout opening with an appropriate drywall saw
(not included).
Post-Construction Installation of the TSW-UMB Universal Mounting
Bracket into a Cutout
2. Loosen the two screws on the included TSW-UMB
Universal Mounting Bracket, and then install the
TSW-UMB bottom first into the opening.
Installing the TSW-UMB
3. Reach into the TSW-UMB and push the rear half back
to ensure it is fully behind the mounting surface. Ensure
the front of the TSW-UMB is level. Then, tighten the two
screws to complete the installation.
CAUTION:
To avoid damage to the bracket, do not
overtighten the screws.
Completing the TSW-UMB Installation
4. Make connections to the TSW-552 using Crestron
®
power supplies and Crestron equipment. Power and
data connection to the TSW-552 is provided by a single
Ethernet cable connected to the LAN port at the rear of
the unit. A Crestron PoE power supply or PoE-capable
network switch is recommended (both sold separately).
Apply power after the Ethernet cable is connected.
Hardware Connections for the TSW-552
5. Carefully hold the touch screen over the TSW-UMB and
gently place it in position. The magnets on the rear of the
touch screen hold it in place on the TSW-UMB.
Pre-Construction Bracket
Use a tie wrap to hold the cable
until the TSW-552 is mounted.
TSW-UMB
Push the top surface
downward to install
the bottom half first.
TSW-UMB
Loosen both of the screws.
Push the rear half back.
Ensure the front is level.
Then, tighten both screws.
Reset Button
LAN PoE:
10BASE-T /
100BASE-TX
Ethernet to LAN
