Crestron TS-770-GV, Quick Start Manual, Page: 3 / 6

Configure the Touch Screen
When power is applied for the first time, the following screen is displayed.
The touch screen may take up to two minutes to boot.
Touch the screen to display the main Setup screen (TS-1070 shown).
Device settings for the touch screen may be configured using the built-in
setup screens or the web configuration interface. For more information
on configuring the touch screen, refer to the
TS-770 and TS-1070 Product
Manual (Doc. 8555) .
Access the Device Setup Screens
To access the built-in setup screens, place five fingers on the display and
hold for 15 seconds.
Use the setup screens to configure various settings for the touch screen,
including Ethernet setup, IP table setup, audio setup, display setup,
standby timeout, application selection, diagnostics, and the virtual
toolbar.
3
TS-770-GV and TS-1070-GV
Quick Start
7 in. and 10.1 in. Tabletop Touch Screens, Government Version