Software
Crestron
Touch The PC Driver
Insert the tinned connection into the Cresnet connector and tighten the retaining
screw. Repeat the procedure for the other three conductors.
Crestron RJ-45 Cabling
CAUTION:
The 15-foot, 10-pin RJ-45 connector cable supplied by Crestron is a
custom cable and is the only one that should be used. The end of the cable has a
metal shield that is required to protect the equipment. Using non-Crestron cables will
result in damage to the product. Other cables lengths are available from Crestron.
NOTE:
When connecting the touchpanel to the interface module, do not confuse
the 8-pin audio cable with the 10-pin net/video cable.
A 15-foot, RJ-45, 10-position, NET/VIDEO cable is supplied with the TPS-IMPC.
The cable is available to provide optional lengths; part number TPS-CBL-3 is the 3-
foot version, TPS-CBL-6 is a 6-foot version, and TPS-CBL-9 is the 9-foot version.
Contact Crestron customer service for further information.
A 15-foot, RJ-45, Siamese (two cables joined together) cable is available from
Crestron. The cable minimizes the number of individual cables attached to the
touchpanel. The Siamese cable consists of a 10-position NET/VIDEO cable, an 8-
position AUDIO cable and is available to provide optional lengths. Part number
TPS-CBL-S3 is the 3-foot version, TPS-CBL-S6 is a 6-foot version, and TPS-CBL-
S9 is the 9-foot version. This cable may be used for any system configuration when
NET/VIDEO and AUDIO connections are necessary. Contact Crestron customer
service for further information.
A 15-foot, RJ-45, Triamese (three cables joined together) cable is supplied with the
TPS-IMC-BV. The cable minimizes the number of individual cables attached to the
touchpanel. The Triamese cable consists of a 10-position NET/VIDEO cable, 10-
position RGB video cable, an 8-position AUDIO cable and is available to provide
optional lengths. Part number TPS-CBL-T3 is the 3-foot version, TPS-CBL-T6 is a
6-foot version, and TPS-CBL-T9 is the 9-foot version. This cable may be used for
any system configuration when NET/VIDEO, RGB video and AUDIO connections
are necessary. Contact Crestron customer service for further information.
DB9F Adapter and RJ-11 Modular Cable
To program the touchpanel for serial communication at the RS-232 port, a DB9F to
RJ-11 adapter and 6-conductor modular (RJ-11) cable is required. These
components are not supplied but are part of the SmarTouch Programming Kit
(Crestron part number ST-PK). If already available, use these components. If
needed, contact Crestron customer service. A cable assembly that consists of a DB9F
to RJ-11 adapter and modular cable is also available from Crestron. Contact Crestron
customer service for part number STCP-502.
The DB9F to RJ-11 adapter is available commercially or contact Crestron customer
service for part number 15556. For RJ-11 modular cable specifications, refer to the
latest revision of the Crestron Network Modular Cable Requirements (Doc. 5682).
This document is available from the Downloads | Product Manuals section of the
Crestron website (
22
•
Touch the PC Driver
Programmer’s Guide – DOC. 5916B
Summary of Contents for Touch The PC Driver
Page 4: ......
