Trim Ring Mount Kits
Crestron
TMK-15L & WMKT-15L
3. When the trim ring is in position, bend the top two flanges of the ring
upward and the bottom two flanges downward.
•
If mounting into the PMK-15L, bend the flanges
approximately 90 degrees.
•
If mounting into the BB-15L, bend the flanges back as far as
they can go.
4. Run the necessary cables for the touchpanel and secure them behind the
drywall.
5. The touchpanel can be installed using the four tapped holes in the
PMK-15L or BB-15L. Refer to the latest revision of the TPS-12L/15L/17L
Operations Guide (Doc. 6355), the TPS-12G/15G-L Operations Guide
(Doc. 6356), or the TPMC-15/17-L Series Operations Guide (Doc. 6354)
for details.
CAUTION:
Allow an air gap of at least 12 inches in the wall cavity above the
touchpanel for heat dissipation.
WMKT-15L Procedure
The procedure in this section provides the necessary steps for installation of the
WMKT-15L into a wall. Complete the steps in the order provided. The only tools or
materials required and not supplied are a drywall saw or equivalent and a level.
1.
Locate an area on the wall that is free of miscellaneous wiring and studs.
2.
Make a small hole near the middle of the designated site; verify that the
location is suitable.
NOTE:
Make the cutout as level and smooth as possible. The mounting plate allows
for only minor leveling adjustments. If a larger cutout is accidentally made, consider
purchasing the Crestron Mud Mount Kit, MMK-15L. It and the mounting plate
supplied with the WMKT-15L provide a cost-effective means of correction.
Essentially, The combination of these two kits makes up the Crestron Mud Mount
Kit for the Wall, WMKM-15L. Simply follow the “WMKM-15L Procedure” in the
latest revision of the Mud Mount Kits Installation Guide (Doc. 6364).
3. Use the drywall saw or equivalent to produce a level, rectangular cutout in
the drywall (refer to the Drywall Cutout dimensions on page 2 for cutout
dimensions).
4. Insert the symmetrical trim ring into the opening, as shown in the following
diagram.
4
•
Trim Ring Mount Kits: TMK-15L & WMKT-15L Installation Guide – DOC. 6365
