Crestron ST-DSN, Operation Manual

Page: 9 / 16

Crestron ST-DSN Docking Station
Industry Compliance
As of the date of manufacture, the ST-DSN has been tested and found to comply
with specifications for CE marking and standards per EMC and
Radiocommunications Compliance Labelling.
NOTE: This device complies with part 15 of the FCC rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful interference,
and (2) this device must accept any interference received, including interference that
may cause undesired operation.
Setup
Power Source
The DC power socket connector on the bottom of the unit is used to supply power
via an external power pack that Crestron supplies with the ST-DSN. It is the
PW-
1215 (110v USA and Canada) or PWI-1215 (220v International). If an external
power pack other than these Crestron models is used, verify that it meets the
required specifications and polarity as shown below.
Power Pack Specifications
CRESTRON POWER PACK INPUT SPECS OUTPUT SPECS
PW-1215 120VAC, 60Hz, 35W 12VDC, 1500mA
PWI-1215 220VAC, 50Hz, 35W 12VDC, 1500mA, 18VA
Power Pack Polarity
Using the ST-DSN to Charge the ST-BTPN
(Rechargeable Battery Pack)
WARNING: The ST-BTPN is shipped fully discharged. Charge the ST-BTPN in a
well-ventilated area away from sparks, open flame, or smoke.
WARNING: Avoid damage to the ST-BTPN and possible physical harm, use only
the specified external power pack PW-1215 (110v) or PWI-1215 (220v) or
equivalent when charging with the ST-DSN.
There are three possible methods of charging the ST-BTPN with the ST-DSN. All
methods are considered fast charging and take between 2.7 and 6 hours for a fully
discharged ST-BTPN. Using the touchpanel during charging may take up to 6 hours
and is only permissible with certain Crestron wireless touchpanel models.
Operations Guide – DOC. 6095 Docking Station: ST-DSN
•
5