DO
GUIDE
2. Insert the module into the SFP+ cage by doing the following:
a. Verify that the top of the module is visible.
b. With the dust cap facing you, insert the module into the SFP+ cage until the module
latches into place.
3. Remove the dust caps from the LC connectors on one end of the fiber-optic cable (patch
cord included with the SFP-10-G-S-U, SFP-10-G-S-D, SFP-10G-S-U-10, and
SFP-10G-S-D-10). Save the dust caps for future use.
NOTE:
Depending on the fiber-optic cable being used, the cable provides single or dual
LC connectors. The included patch cord provides a single LC connector on one end.
4. Inspect and clean the fiber-optic endfaces of the LC connectors.
5. Remove the dust cap from the SFP+ module. Save the dust cap for future use.
SFP-10G Series
10G SFP+ Transceiver Modules
DO
Install the Module
An SFP+ (enhanced small form-factor pluggable) transceiver module plugs into the SFP+ cage of a Crestron
®
device.
CAUTION:
Observe electrostatic discharge (ESD) precautions when handling SFP+ transceiver
modules. Always wear a wrist strap that connects to an approved grounding source when
installing or coming into contact with the modules.
CAUTION:
To prevent damage to an SFP+ module and to any connected cables, disconnect all
cables before installing or removing a module.
NOTE:
An SFP+ module is a hot-swappable input/output (I/O) device; therefore, there is no
need to power down a Crestron device when installing or removing a module.
To install an SFP+ module into an SFP+ cage, do the following:
NOTE:
Do not remove the dust cap from the SFP+ module until directed to do so in the
following procedure. In addition, always keep the dust caps on the fiber-optic cable connectors
until ready to make a connection.
1. Verify that the bail latch is closed.
DO
Check the Box
QTY PRODUCT
PART NUM.
SFP-10G-S-U and SFP-10G-S-D Only
1
Patch Cord, LC-to-SC
2047106
1
Adapter, SC-to-SC
2047107
SFP-10G-S-U-10 and SFP-10G-S-D-10 Only
10
Patch Cord, LC-to-SC
2047106
10
Adapter, SC-to-SC
2047107
Not Included: Wrist Strap, Antistatic Mat or Foam, Fiber-Optic Endface Cleaning Tools and Inspection Equipment
Bail Latch
in Closed Position
Dust Cap
Bail Latch
in Open
Position
RX Optical Bore
TX Optical Bore
Dust Cap
Bail Latch
in Open
Position
TX/RX Optical Bore
SFP+ Module with Dual LC Connectors
SFP+ Module with Single LC Connector
Top of Module
Top of Module
