The Crestron®
is an RFID card reader that integrates into
supported room scheduling applications and custom room control
projects via a
or
touch screen. The
RFID-USB installs next to the touch screen, allowing users to easily
authenticate with or communicate to the touch screen by scanning an
RFID card. The RFID-USB also integrates with a Crestron control system
for custom room control or access projects.
NOTE:
A third-party Quick Start is provided in the box with the
RFID-USB for compliance purposes only. The Crestron Quick Start
should be used when installing the RFID-USB.
In the Box
1
RFID-USB, RFID Card Reader
Additional Items
4
Adhesive Pads (2058188)
1
Cable, Micro USB to USB A, 17.72 in. (450 mm) (2058186)
1
Frame, Glass Mount (2058187)
1
Label, Adhesive (2058189)
Install the RFID-USB
The RFID can be installed into drywall or onto a flat, smooth surface
such as glass. Procedures for each installation are provided in the
sections that follow.
NOTE:
To avoid RF interference, ensure that no metal object or surface
is located within 10 cm of the RFID-USB after installation
Drywall Mounting
The following is required for this installation: a level, a roll of masking
tape, a drill, and a surface cleaning product that does not leave a film.
NOTE:
The following procedure assumes that the touch screen has
been installed into drywall using its provided mounting bracket or the
TSW-770/1070-MSMK-ANG multisurface mount kit. For more
information, refer to the
TSW-570, TSW-770, and TSW-1070 Quick
, the
TSS-770 and TSS-1070 Quick Start
, or the
TSW-770/1070-MSMK-ANG Quick Start
.
1. Clean and dry the mounting surface thoroughly.
2. Select the mounting location for the RFID-USB. The RFID-USB should
be mounted below the touch screen and should not be mounted more
than 8 in. (203 mm) away from the touch screen.
3. Using the level, tape a horizontal reference line on the mounting
surface that aligns with the lower edge of the RFID-USB. Ensure the
reference line is level before proceeding.
4. Drill a 3/4 in. (19 mm) diameter hole into the mounting surface at the
center of where the RFID-USB will be mounted.
5. Route the provided USB cable through the drywall from the touch
screen cutout to the hole created in step 4 above. Ensure that the
micro USB end of the cable is routed to the mounting location.
6. Attach the USB A cable end to the touch screen rear housing.
RFID-USB
Quick Start
RFID Card Reader
1