Crestron
QM-FTDC
FlipTop Data Center
Installation
NOTE:
This section does not apply to NB models.
The QM-FTDC is shipped with ten large blank buttons. You can order a variety
of button kits (sold separately) to add as many as 20 engraved or blank buttons.
Button Kits
KIT NUMBER
DESCRIPTION
FT-BTNB-L
One large button engraved as desired
FT-BTNB-L-BLANK
One large button not engraved
FT-BTNB-S
Two small buttons with divider engraved as desired
FT-BTNB-S-BLANK
Two small buttons with divider, not engraved
Button Installation
To replace the large buttons with small buttons, follow this procedure.
A 1/16" Allen (hexhead) wrench is required to remove the button faceplate.
1. Remove the four Allen screws that secure the button faceplate.
2. While holding adjacent buttons in place, carefully pull the button(s) to
be replaced from the rubber membrane.
3. Carefully press the two small replacement buttons in place, making
sure LED window faces up. Use care not to dislodge the membrane and
circuit board.
NOTE:
The removable buttons fit snugly on the rubber membrane. Remove
carefully to avoid pulling the membrane from the unit.
4. The divider bar slips into the slots on the back of the faceplate.
5. Replace
the
faceplate.
Button Installation
Operations & Installation Guide – DOC. 6312A
FlipTop Data Center: QM-FTDC
•
17