Crestron PC-350V Series, Product Manual

Page: 27 / 69

27 • PC-350V-12 and PC-350V-18 Product Manual — Doc. 9212A
Outlet Test
Before making connections to the power controller, perform an outlet test to ensure that the
outlet the power controller is plugged into is properly wired:
1. Connect the included power cord to the power controller.
2. Plug the power cord into the outlet and wait until the POWER LED and PROTECT LED on
the power controller light green. This process may take several seconds.
3. Verify that the red FAULT LED is not lit.
If the FAULT LED lights, then the connected outlet is not wired correctly. Fault details can
be viewed in the device web user interface. For more information on monitoring and
configuring the device parameters, refer to the
PC-350V Series Product Manual .
NOTE: Do not make any connections to the device until the connected outlet is wired
correctly.
4. Repeat steps 1 and 2 until the FAULT LED stops lighting when the device is plugged into
the outlet.