16 • IV-SAM-VXP-1B and IV-SAM-VXS-1B
Product Manual — Doc. 9324A
Installation
Use the following procedures to install the Automate VX system.
In the Box
Qty.
Description
1
IV-SAM-VXP-1B or IV-SAM-VXS-1B, Automate™ VX Camera Switcher
Additional Items
2
Rail, 20 in. (508 mm)
1
Power Cord, IEC
1
Wi-Fi™ Network Antenna
1
SDI to HDMI® Signal Converter
1
DisplayPort™ to HDMI (female) Signal Adapter
1
Feet Set, Chassis
IV-SAM-VXP-1B Only
8
Cable, MiniDIN to BNC
Wire the Camera System
To perform basic wiring for the camera system:
1. Designate a number for each PTZ camera in your system.
2. Mount the cameras in as described in the appropriate
documentation for your 1 Beyond
3. Connect each PTZ camera to the SDI® ports of the Automate VX device using HD-SDI
cables. Ensure the numbered SDI port corresponds to the camera number determined in
step 1.
NOTE: Each PTZ camera should be connected to a network switch via Ethernet and
can be powered via PoE+ (Power over Ethernet Plus) with 30 W power.
4. Connect the Ethernet 2 port on the camera switcher device to the network switch via an
Ethernet cable.