iMedia Receiver with Video & Mic Input Crestron
IM-RXV1-M & IM-RXV3-M
Setup
Network Wiring
When wiring an iMedia system, consider the following:
•
Use Crestron Certified Wire.
•
Use Crestron power supplies for Crestron equipment.
•
Provide sufficient power to the system.
CAUTION:
Insufficient power can lead to unpredictable results or damage
to the equipment.
IM Wiring
Using a proprietary signal routing solution, RGBHV, composite video, audio, power
and control signals are all transported using a single cable solution called iMedia.
The iMedia transport system port is capable of managing computer RGB, composite
video, and audio signals simultaneously through one CresCAT-IM cable, simplifying
installations.
Routing CresCAT-IM cable (low-skew CAT5e) is less expensive and a much
simpler solution for wiring iMedia systems than routing multi-colored,
multi-conductor coax cable. All Crestron products using the iMedia transport system
are capable of sending and receiving iMedia signals via CresCAT-IM cable.
Installation of any iMedia device is as simple as installing one iMedia cable from
output to input. Installations are affordable and fast.
Pin Assignments
The pin assignment is based on the EIA/TIA 568B RJ-45 Jack standard.
Power is supplied to the IM transmitters via the audio circuit.
To determine which pin is number 1, hold the cable so that the end of the eight pin
modular jack is facing you, with clip down and copper side up. When looking down
at the copper connections, pin 1 is on the far right.
iMedia Pin Assignment
RJ-45 Male
Connector
RJ-45 Pin
Number
Wire Colors
iMedia Assignment
RGB, Composite and
Audio
1
White/Orange
- RGB Red
2
Orange
+ RGB Red
3
White/Green
- RGB Green
4
Blue
+ Audio/Power
5 White/Blue -
Audio/Power
6
Green
+ RGB Green
7
White/Brown
- RGB Blue / Composite
8
Brown
+ RGB Blue / Composite
NOTE:
Power is supplied to pins 4 and 5 from the IM receivers.
12
•
iMedia Receiver: IM-RXV1-M & IM-RXV3-M
Operations & Installation Guide – DOC. 6593A
