DO
GUIDE
HD-RX-201-C-E
DM Lite Multiformat Switch and Receiver
DO
Connect the Device
Connect the device as required for the application.
NOTES:
•
A power pack is included with the HD-RX-201-C-E. If a power pack is also included with
the compatible transmitter, connect a power pack to either the receiver or transmitter.
Do not connect a power pack to both devices simultaneously. Power is transmitted over
the cable that connects the FROM TX port on the receiver to the TO RX port on
the transmitter.
•
Cabling that connects the FROM TX port to the TO RX port is designed for intrabuilding
use only.
The SERVICE port on the front panel of the device is for factory use only.
DO
Install the Device
Mount the device onto a flat surface or rack rail.
Mount onto a Flat Surface
Using four mounting screws (not included), mount the device onto a flat surface such as a wall.
Mount onto a Rack Rail
Mount the device onto the front or rear rail of a rack. Position either the left or right mounting flange
of the device so that the holes align with the holes in the rack. Then, secure the device to the rack
using two mounting screws (not included).
DO
Check the Box
QTY
ITEM
PART NUM.
1
Connector, 2-Pin
2003574
2
Connector, 5-Pin
2003577
1
Power Pack, 24 Vdc 1.25 A, 100-240 Vac
2045870
HDMI:
From HDMI
®
audio/video
source
FROM TX:
From TO RX
link output of
DM Lite transmitter
HDMI OUTPUT:
To HDMI
display
AUDIO:
Balanced/
unbalanced stereo
line level audio output
IR:
To IR
controllable
device
COM:
To
RS-232
device
10BASE-T/
100BASE-TX
Ethernet to
local area
network
24V
1.25A:
From included
power pack
SERVICE:
For factory
use only
