31 • GL-IPAC-SW8
Product Manual — Doc. 7389C
l
When the light level is less than L1, both Lo and Hi lights are on.
l
When the light level is greater than L2, both Lo and Hi lights are off.
l
When the light level is between L1 and L2, Lo lights are on and Hi lights are off.
To adjust the levels:
1. Press L 1, L 2, or L 3 to switch between the available levels.
2. Use ▼ and ▲ to change the threshold.
3. Press Band to adjust the hysteresis buffer.
4. Press Done to return to the Photo Cell List screen.
Light Levels Illustration
Assign Photo Sensors to Loads
The Photocell Assignments screen assigns photo sensors to loads.
1. Use ▼ and ▲ to highlight the desired load.
2. Press MODE to assign a photo sensor function to the load. Each function (Hi, Med, Lo, Off)
operates the connected load according to the settings established on the Photocell Setup
screen.
