27 • GL-IPAC-SW8
Product Manual — Doc. 7389C
5. Set the type of sensor on the GLS-SIM using the DIP switches. Refer to the
Operations and Installation Guide (Doc. 6768)
. Status shows the current sensor state
based on the set type.
Press OK to return to the Occ Sensor List screen.
Sensor C0.1 Screen
Assign an Occupancy Sensor
On the Sensor Load Assignment screen, loads L1.1 through L1.8 are displayed. For an external
panel the loads are listed L2.1 through L2.56. The first digit represents the panel and the second
digit represents the load. Next to panel and load, in parenthesis, functions already assigned to
that sensor display as single letters. A p designates photo sensor assignment. An o designates
occupancy sensor assignment. The occupancy sensor that is assigned to the load is listed on the
right side of the screen. If no sensor has been assigned, - - - is displayed.
Sensor Load Assignment Screen
Assign an Occupancy Sensor to a Load
In this menu, assign occupancy sensors to specific loads.
1. Select Edit then use ▼ and ▲ to select the occupancy sensor.
2. OK saves the assignments and returns to the Setup menu.
3. Press Set to confirm the selection.
