FT2A-PWR-UK-1-C14
AC Power Outlet Module for FT2 Series, UK, C14 Inlet
Installation Guide
Description
The Crestron
®
FT2A-PWR-UK-1-C14 module provides one UK-style ac power outlet for
use with the FT2 series of FlipTop™ cable managment devices. The module may be used
to power laptops and other ac-powered devices at the table.
The FT2A-PWR-UK-1-C14 module is suitable for use in the United Kingdom, Singapore,
Saudi Arabia, and other countries or regions where Plug Type G power outlets are used.
Additional Resources
Visit the product page on the Crestron website (
www.crestron.com
)
for additional information and the latest firmware updates. Use a QR
reader application on your mobile device to scan the QR image.
infiNET EX logo only needed for infiNET
EX products. The mere mention of
infiNET EX in a document is not cause to
use the logo.
Overview
The FT2A-PWR-UK-1-C14 has the following specifications:
• Each FT2A-PWR-UK-1-C14 module provides one UK Type G ac power outlet that is
rated for 10 A (total) at 220–240 Vac, 50/60 Hz.
• An IEC C-14 socket is provided on the bottom of each module, which is used to
connect the module to a power source via an IEC power cord rated for 10 A or better
(not included).
• One blank plate is provided with the FT2A-PWR-UK-1-C14 module for use with
low-profile power cords. Refer to the note below.
Installation
Use the following procedure to install the FT2A-PWR-UK-1-C14 module into an FT2 series
assembly.
If the FT2A-PWR-UK-1-C14 module is being installed as part of a new FT2 series FlipTop
device installation, proceed to step 3 below.
Install the FT2A-PWR-UK-1-C14 Module
1.
Remove the magnetic bezel from the FT2 series assembly by grasping the inside of
the bezel and pulling it up and away firmly from the assembly until the magnetic hold
is broken.
2.
Unscrew and remove the two locking bars that secure the module row required for
installation.
For example, if installing the FT2A-PWR-UK-1-C14 module in the front row of an
FT2-700 series FlipTop device, remove the front and center locking bars.
3. Connect an IEC power cord (rated for 10 A or better) to the IEC C-14 socket on the
bottom of the FT2A-PWR-UK-1-C14 module.
FT2A-PWR-UK-1-C14
module (bottom view)
IEC C-14
socket
FT2A-PWR-UK-1-C14
module
Blank plate
Low-profile power
cord must clear top
of FT2 series bezel
NOTE:
If low-profile power cords are expected to be used with the
FT2A-PWR-UK-1-C14 module, ensure that the provided blank plate is installed to the
right of the module.
Each module is 1.97 x 1.97 in (50 x 50 mm) and occupies two empty module spaces in an
FT2 series assembly.
Locking bar
(center)
Locking bar
(rear)
Locking bar
(front)
