DigitalMedia 8G+™ Transmitter 200
Crestron
DM-TX-200-C-2G
Uploading and Upgrading
Crestron recommends using the latest programming software and that each device
contains the latest firmware to take advantage of the most recently released features.
However, before attempting to upload or upgrade it is necessary to establish
communication. Once communication has been established, files (for example,
firmware) can be transferred to the control system (and/or device). In addition, the IP
table of the device can be configured.
Establishing Communication
Use Crestron Toolbox for communicating with the DM-TX-200-C-2G; refer to the
Crestron Toolbox help file for details.
A PC running Crestron Toolbox communicates with the DM-TX-200-C-2G in the
following ways:
•
Via a DM switcher using TCP/IP or USB communication. TCP/IP provides
a faster method of communication than USB.
•
Via a DM 8G+ receiver/room controller (for example, DM-RMC-100-C)
using TCP/IP communication.
Via DM Switcher
TCP/IP Communication via DM Switcher
DM 8G+
DM Switcher
PC Running
Crestron Toolbox
LAN
DM-TX-200-C-2G
To establish TCP/IP communication between the PC and the DM-TX-200-C-2G via
a DM switcher:
1.
Establish communication between the PC and the DM switcher as described
in the latest version of the DigitalMedia Switchers Operations Guide
(Doc. 6755).
2.
Use the Device Discovery Tool in Crestron Toolbox to find the IP address
of the DM-TX-200-C-2G. The tool is available in Toolbox version 1.15.143
or later.
3.
Use the Address Book in Crestron Toolbox to create an entry for the
DM-TX-200-C-2G using the
TCP
connection type and enter the IP address
of the DM-TX-200-C-2G.
4.
Display the “System Info” of the DM-TX-200-C-2G (click the
icon);
communications are confirmed when the device information is displayed.
22
•
DigitalMedia 8G+™ Transmitter 200: DM-TX-200-C-2G
Operations & Installation Guide – DOC. 7320A
