DigitalMedia 8G+™ Transmitter 200
Crestron
DM-TX-200-C-2G
Installation
To prevent overheating, do not operate this product in an area that exceeds the
environmental temperature range listed in the table of specifications.
The DM-TX-200-C-2G is designed for installation in a 2-gang electrical box
(not included). A minimum mounting depth of 2.5 inches (64 mm) is required.
The DM-TX-200-C-2G also fits a 2-gang opening in a 6 inch (153 mm) deep floor
box (not included).
NOTE:
Before installing the DM-TX-200-C-2G, verify that the required wiring has
been fed through the electrical box/floor box (not included). Connect the wiring to
the rear of the DM-TX-200-C-2G (refer to “Hardware Hookup” on page 18 for
information about connections to the rear of the DM-TX-200-C-2G).
Installation into Electrical Box
To install the DM-TX-200-C-2G into an electrical box, do the following (refer to the
illustration below):
1.
Using a Phillips head or straight blade screwdriver, attach the
DM-TX-200-C-2G to the electrical box using the four included
#6-32 x 3/4” truss combo head screws (2009211).
2.
Attach a decorative style faceplate (not included) to the front panel of the
DM-TX-200-C-2G using four screws (not included).
DM-TX-200-C-2G Installation into Electrical Box
2-Gang Electrical Box
(Not Included)
DM-TX-200-C-2G-W-T (6505823)
or
DM-TX-200-C-2G-B-T (6505824)
#6-32 x 3/4”
Truss Combo
Head Screws (4)
(2009211)
2-Gang Faceplate
with Attachment Screws (4)
(Not Included)
16
•
DigitalMedia 8G+™ Transmitter 200: DM-TX-200-C-2G
Operations & Installation Guide – DOC. 7320A
