DigitalMedia 8G Fiber Receiver 200
Crestron
DM-RMC-200-S/S2
When setting the IP ID, consider the following:
The IP ID of each unit must match an IP ID specified in the SIMPL
Windows program.
Each device using IP to communicate with a control system must have a
unique IP ID.
Supplied Hardware
The hardware supplied with the DM receiver is listed in the following table.
Supplied Hardware for the DM-RMC-200-S/DM-RMC-200-S2
DESCRIPTION PART
NUMBER
QUANTITY
Mounting Bracket
2032478
1
Screws, 06-32 x 1/4”, Pan, Phil
2007215
4
Screws, 06-32 x 1”, Pan, Phil
2007250
2
Screws, 06-32 x 3/4”, Slot
2009211
4
Standoffs, 06-32 x 1-1/4”
2007056
4
Tie Wraps
2013608
2
Installation
Ventilation
The DM receiver should be used in a well-ventilated area. The venting holes should
not be obstructed under any circumstances.
To prevent overheating, do not operate this product in an area that exceeds the
environmental temperature range listed in the table of specifications.
Mounting
The DM receiver mounts to a 2-gang electrical box (not included). To mount the DM
receiver, perform the following steps (refer to the illustration on the following page):
1.
Attach the four included 06-32 x 1-1/4” standoffs (2007056) to the studs of
the included mounting bracket (2032478).
2.
Using the four included 06-32 x 3/4” slot head screws (2009211), attach the
included mounting bracket (2032478) to the electrical box.
3.
Ground the DM receiver and attach the proper cables to the rear of the unit
(refer to “Hardware Hookup” which starts on page 21 for information).
4.
Using the four included 06-32 x 1/4” Phillips head screws (2007215), attach
the DM receiver to the standoffs (2007056).
CAUTION:
Excess wire that is pinched between the DM receiver and the
electrical box can short out. Ensure that all excess wire is completely inside the
electrical box and is not between the box and the DM receiver.
18
DigitalMedia 8G Fiber Receiver 200: DM-RMC-200-S/S2
Operations & Installation Guide – DOC. 7246B
