DigitalMedia
™
Cards: DMC Series
Installation instructions for input and output cards are nearly identical:
•
This page shows installation instructions for input cards.
•
Turn over for output card installation instructions.
DMC Series – Input Cards
CAUTION:
Cards are static sensitive. Standard electrostatic discharge precautions should be
followed when handling cards.
CAUTION:
Cards are not hot swappable. Always remove power to the DigitalMedia switcher
when performing any work on it.
Input cards occupy the slots along the left and right of DigitalMedia switcher. The DigitalMedia
switcher must be disconnected from its power source before installing or removing input cards.
Follow the instructions below to install the input cards.
1. Remove slot covers by unscrewing two Phillips head screws.
2. Slide card in, make sure board is properly aligned with card guides. Use caution to avoid
damage to pins on the bottom of the cards.
3. When card is 1/4 inch from fully seated position, align thumb screws before seating into
backplane.
4. Firmly seat card in backplane by pushing card evenly just below thumb screws until it is
fully inserted.
5. Tighten thumb screws by hand to secure input card.
NOTE:
Do not over tighten thumb screws.
Installing Input Card (DM-MD8x8 Shown)
Crestron Electronics, Inc.
Installation Guide – DOC. 6757A
15 Volvo Drive
(2022814)
Rockleigh, NJ 07647
12.08
Tel: 888.CRESTRON
Specifications subject to change without notice.
Fax: 201.767.7576
www.crestron.com
