Crestron
DA-1700CW
Docking Assembly for STX-1700CW/CXPW
Example Program
An example program for the DA-1700CW is available from the Example Program
section of the Crestron website (http://www.crestron.com/exampleprograms). Search
for DA-1550CW_DA-1700CW Example Program (ZIP).
Operation
The DA-1700CW docks the touchpanel, provides power and communication, and
recharges the ST-BTPN. Operation consists of docking the touchpanel (performed by
hand) into the DA-1700CW or undocking electrically via the control system and then
removing by hand.
Docking the Touchpanel
To dock the touchpanel, refer to the procedure below.
NOTE:
Do
not
dock the touchpanel into the DA-1700CW without the ST-BTPN
being installed in the touchpanel. Operating power for the DA-1700CW is supplied
through the electrical contacts of the ST-BTPN. If the ST-BTPN is not installed, the
DA-1700CW will not electrically unlatch the touchpanel.
1. Refer to the diagram below. Insert the bottom edge of touchpanel docking
plate (located on the rear of the touchpanel) into DA-1700CW directly
behind the front panel.
Insert Touchpanel
2. Refer to the diagram on next page. Make sure that the touchpanel is
squarely seated
in DA-1700CW and press upper edge of touchpanel
inward to dock the touchpanel. The touchpanel will snap into position.
Operations and Installation Guide - DOC. 6104A
Docking Assembly for STX-1700CW/CXPW: DA-1700CW
•
13
