Crestron Crestron Isys TPS 6000L, Operation Manual, Page: 6 / 52

15 Inch Lectern Touchpanel Crestron Isys™ TPS-6000L
Expansion Slots
Each TPS-6000L has three dedicated slots for additional functionality. The slots are
empty with blank cover plates. Cards are purchased separately. Installation
instructions are provided with each card. Each card features the following:
•
TPS-ENETL – a 10/100 BaseT Ethernet card provides Ethernet
capability to the touchpanel.
•
TPS-VIDL – a TV video digitizer card that allows NTSC/PAL video
to be played in a window on the touchpanel or full screen.
•
TPS-XVGAL – a RGB digitizer that scan converts a computer source
up to 1280 x 1024 at 60 Hz (110 Hz @ 640 x 480) vertical rate to a
window on the touchpanel or full screen.
NOTE: The three cards are NOT interchangeable.
Memory
The TPS-6000L ships with 8MB of flash and 8MB of DRAM. Additional memory
(purchased separately) can be installed in the field. The flash can be replaced with
modules of up to 64MB. The DRAM module can be replaced with modules up to
32MB. Installation instructions are provided with each memory module.
Sound
The TPS-6000L has four built-in speakers with power amplifiers. Sound can be
generated by the panel by using downloaded wave files (.WAV) or can be mixed in
from an external line level audio source. The audio amplifiers output two watts per
channel. Refer to "Appendix A: WAV File Audio Messages" on page 28 for WAV
file details. There is a built-in microphone in the touchpanel, which is amplified to
produce a line level differential output. The microphone amplifier has two modes,
AGC or fixed gain. The AGC is selectable using an internal join number, refer to
"Reserved Join Numbers" on page 24.
I/O Connectors
All totaled, there are 13 potential I/O connectors available on the TPS-6000L. Four
of the 13 connectors are resident on the touchpanel as shipped from Crestron. The
remaining nine connectors are optional and require the additional purchase and
installation of expansion cards.
The resident connectors are:
•
NET – The port mates with a four-pin connector, supplied, and is used
to connect the touchpanel to other four-wire devices in the Cresnet
system. If making network connections to the Cresnet peripherals, refer
to the latest revision of the Cresnet Network Interconnect Drawing
(Doc. 5411). This document can be obtained from the Downloads page
(CABLES and MANUAL Libraries) of the Crestron website
(
www.crestron.com) . Search for CRESNET.PDF.
•
AUDIO INPUT – The port mates with a six-pin connector, supplied,
and provides differential/single ended audio input and output.
Description of the pinouts is shown in the table after this paragraph.
2
•
15 Inch Lectern Touchpanel: Crestron Isys™ TPS-6000L Operations Guide - DOC. 5825