Crestron
CNANT
High Performance Antenna
Mounting
Four mounting screws (#8, not supplied) are required to securely mount the CNANT
to an indoor flat surface (2.75” (6.99 cm) square, minimum). Once mounted, the
CNANT can be positioned in any orientation. Depending on the type of material to
which the CNANT is mounted, a drill may be required to predrill holes.
NOTE:
A 15-foot BNC cable (9) is supplied. If a longer cable is required, use cable
type RG-58U. However, distances greater than 50 feet decrease the gain due to cable
losses.
1. Locate a flat suface suitable to mount the CNANT. The surface should
be no more than 50 feet (in cable length) from the receiver.
Do not
mount CNANT inside a metal enclosure.
2. If necessary, predrill holes per the base bracket footprint.
CNANT Base Bracket Footprint (Bottom View)
2.750 in
(6.985 cm)
WHERE:
A = 0.437 in
(1.110 cm)
CLEARANCE FOR
#8 SCREW
(4) PLACES
1.875 in
(4.763 cm)
1.875 in
(4.763 cm)
2.750 in
(6.985 cm)
0.437 in
(1.110 cm)
A
3. Secure base bracket (2) to flat surface with four #8 screws (not
supplied).
4. Thread the male BNC cable (9) through the arm (1) and connect to the
antenna holder assembly (4).
5. If necessary, secure the BNC cable (9) to the arm (1) with two wire
clips. The wire clips can are affixed to the bracket’s underside.
6. Connect other male BNC connector end of cable (9) to receiver.
7. Tighten four SEMS screws (3) to fix CNANT in a desired orientation.
Operations & Installation Guide - DOC. 8132
High Performance Antenna: CNANT
•
5
