Crestron
CNANT
High Performance Antenna
Setup
Assembly
The CNANT is provided in several pieces: asssembly is required. Verify that all the
pieces (in the quantities required) are on hand; refer to table below. Follow the
assembly procedure that follows; refer to the exploded view on the next page. The
only tool required is a Phillips tip screwdriver. Not all pieces may be used during the
assembly procedure. Those pieces that are omitted are to be used during the
mounting procedure.
Items Shipped with CNANT
ITEM #
ITEM
PART NUMBER
QUANTITY
1
Arm
02432
1
2
Base Bracket
02431
1
3
Pan Phillips Head SEMS Screw
#10-32 x 0.312" LG
4
4
Antenna Holder Assembly
17354
1
5
Reflector Rod
02434
4
6
Pan Phillips Head Screw
#8-32 x 0.375" LG
4
7
Red Caps
15764
4
8
Flex Antenna
XPD31
1
9
15 Foot BNC Cable
15764
1
NOTE:
Refer to the following exploded view of the CNANT when assembling and
mounting the unit. This view provides item numbers to easily identify each part of
the CNANT.
1. Secure arm (1) to base bracket (2) with two SEMS screws (3). Do not
fully tighten.
2. Secure antenna holder assembly (4) to arm with two SEMS screws (3).
Do not fully tighten.
3. Secure four reflector rods (5) to antenna holder assembly with four
screws (6).
4. Cover ends of reflector rods (5) with four red caps (7); one red cap per
rod.
5. Attach male BNC connector from flex antenna (8) to female BNC
connector from antenna holder assembly (4).
Operations & Installation Guide - DOC. 8132
High Performance Antenna: CNANT
•
3
