24-Port Managed PoE Switch
Crestron
CEN-SWPOE-24
20
•
24-Port Managed PoE Switch: CEN-SWPOE-24
Operations Guide – DOC. 7036C
Configuration Backup
It is possible to back up the file containing current configuration settings of the
switch to a computer’s hard drive. The default configuration filename is config.bin.
To back up current configuration settings, click the
General
selection and then click
the
Firmware Tools
subselection. The “Firmware Tools” screen opens.
Back up the current configuration as follows:
1. Click
Back Up
to open the “File Download” window.
2. Click
Save
to open the “Save As” window.
3. Navigate to the location on the hard drive to which the configuration file
should be saved.
4. (Optional) In the
File name
text box, enter a new file name if desired.
5. Click
Save
to open the “Download Complete” window and save the file.
6. When the download is complete, click
Close.
Load the configuration file to any CEN-SWPOE-24 switch by performing the
configuration restore process discussed in “Configuration Restore” section on page
19.
Configuration Reset
(Factory Defaults)
To restore factory default configuration settings of the switch, click the
General
selection and then click the
Firmware Tools
subselection. The “Firmware Tools”
screen opens.
•
Click
Reset
to restore factory default settings.
•
Click
Reset But Keep Network Settings
to restore factory default settings
except the network settings.
NOTE:
The switch restarts to allow the factory default settings to take
effect. After 15-20 seconds, the home screen opens so the settings can be
reviewed.