Wideband RGB Matrix Switcher
Crestron
CEN-RGBHV
2. 1 – 8 on CEN-RGBHV8X4 and CEN-RGBHV8X8; 1 – 12 on CEN-RGBHV12X4 and
CEN-RGBHV12X8; 1 – 16 on CEN-RGBHV16X16.
3. 1 – 4 on CEN-RGBHV8X4 and CEN-RGBHV12X4; 1 – 8 on CEN-RGBHV8X8 and
CEN-RGBHV12X8; 1 – 16 on CEN-RGBHV16X16.
4. 16 on CEN-RGBHV8X4 and CEN-RGBHV8X8; 24 on CEN-RGBHV12X4 and
CEN-RGBHV12X8; 32 on CEN-RGBHV16X16.
5. To determine which is pin 1 on the cable, hold the cable so that the end of the eight pin modular jack
is facing away from you, with the clip down and copper side up. Pin 1 is on the far left.
6. Refer to “Fuse Replacement” on page 20 for additional details.
Industry Compliance
This product is Listed to applicable UL Standards and requirements by Underwriters
Laboratories Inc.
(E302724)
As of the date of manufacture, the CEN-RGBHV has been tested and found to
comply with specifications for CE marking and standards per EMC and
Radiocommunications Compliance Labelling.
NOTE:
This device complies with part 15 of the FCC rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful interference and
(2) this device must accept any interference received, including interference that may
cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy
and if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
16
•
Wideband RGB Matrix Switcher: CEN-RGBHV
Operations Guide – DOC. 6612C
