Network Video Streamer
Crestron
CEN-NVS100
RTSP Port:
Enter the RTSP port number. The default port number is 554.
RTP Video Port:
Enter the video channel port number for RTP (Real Time
Transport Protocol). The port number must be an even number. The default port
number is 5560.
RTCP Video Port:
(Read only) Specifies the video channel port number for RTCP
(Real Time Transport Control Protocol). The port number is the port number of the
RTP video port plus 1. The default port number is 5561 (5560 + 1).
RTP Audio Port:
Enter the audio channel port number for RTP. The port number
must be an even number. The default port number is 5558.
RTCP Audio Port:
(Read only) Specifies the audio channel port number for RTCP.
The port number is the port number of the RTP audio port plus 1. The default port
number is 5559 (5558 + 1).
Multicast Settings for Stream 1/Stream 2:
Always Multicast:
Select the checkbox to enable multicast.
Multicast Group Address:
Enter the address to be used by sources to send
content and by receivers to receive content.
Multicast Video Port:
Enter the video channel port number for multicast.
The port number must be an even number. The default setting is 5560.
Multicast RTCP Video Port:
(Read only) Specifies the video channel port
number for multicast RTCP. The port number must be the port number of the
multicast video port plus 1. The default setting is 5560 plus 1 (5561).
Multicast Audio Port:
Enter the audio channel port number for multicast.
The port number must be an even number. The default setting is 5562.
Multicast RTCP Audio Port:
(Read only) Specifies the audio channel port
number for multicast RTCP. The port number must be the port number of the
multicast audio port plus 1.
Multicast TTL [1-255]:
Enter the number of routers (hops) that multicast
traffic is permitted to pass through before expiring on the network. Valid
values range from 1 to 255.
Configuring DDNS Settings
NOTE:
Version 0100i of the CEN-NVS100 is not compatible with the Crestron
DDNS (Dynamic Domain Name Service).
Configuring Client Access Settings
Configuration of a client access list provides one or more IP address ranges that are
allowed to access the CEN-NVS100. Ranges of addresses that are denied access to
the CEN-NVS100 can also be configured. Addresses can also be deleted from the
allowed or denied list of IP addresses.
To configure access list settings, click
Configuration
on the CEN-NVS100 home
page and then click
Access List
in the left-hand column of the page. The “Access
List” configuration page opens.
34
•
Network Video Streamer: CEN-NVS100
Operations & Installation Guide – DOC. 6873A
