Product Manual — Doc. 9310A
CAEN-UMP1X2-DIN-PWS • 9
Install the DIN-HUB
The DIN-HUB is not included with the CAEN-UMP1X2-DIN-PWS.
Included equipment to prepare the DIN-HUB:
l
Three 3-pin terminal blocks (included with the DIN-HUB)
l
Eight 4-pin terminal blocks (included with the DIN-HUB)
l
Three jumper wires (included with the CAEN-UMP1X2-DIN-PWS)
To install the DIN-HUB:
1. Connect the three 3-pin terminal blocks.
2. Insert the jumper wires into the 3-pin terminal blocks. Ensure the wires are fully inserted in
the terminals.
3. Use a small flat-head screwdriver to secure the wires by tightening the screws on the
terminal block. Tighten to 2 in.-lbs (0.25 nm).
4. Use a small flat-head screwdriver to remove the end clamp from the
CAEN-UMP1X2-DIN-PWS.
