Crestron C2N-TTVFM, Operation Manual

Page: 12 / 44

TV & FM Radio Tuner Crestron C2N-TTVFM
8
•
TV & FM Radio Tuner: C2N-TTVFM Operations Guide - DOC. 6266A
SAVE Button
Use the SAVE button to save a station frequency in a preset location. To save a preset,
select the desired station, use the MODE switch to select the preset mode, use the
up/down buttons to select the preset location, and then press SAVE . The display will
briefly show “SAVE” as the preset is saved.
SETUP LED and Pushbutton
The TV/FM Tuner is Touch Settable ID (TSID) ready. The SETUP pushbutton and
its associated LED are located on the rear panel and are used for setup of the unit’s
network ID during the initial configuration of a Cresnet system or when the device is
being added/replaced. Refer to “Method B (Touch Settable IDs)” on page 10
for
detailed information.
Industry Compliance
As of the date of manufacture, the TV/FM Tuner has been tested and found to
comply with specifications for CE marking and standards per EMC and
Radiocommunications Compliance Labelling.
NOTE: This device complies with part 15 of the FCC rules. Operation is subject to
the following two conditions: (1) these devices may not cause harmful interference,
and (2) these devices must accept any interference received, including interference
that may cause undesired operation.
Setup
Network Wiring
CAUTION: In order to ensure optimum performance over the full range of your
installation topology, Crestron Certified Wire, and only Crestron Certified Wire,
should be used. Failure to do so, may incur additional charges if support is required
to identify performance deficiencies as a result of using improper wire.
CAUTION: Use only Crestron power supplies for Crestron equipment. Failure to
do so could cause equipment damage or void the Crestron warranty.
CAUTION: Provide sufficient power to the system. Insufficient power can lead to
unpredictable results or damage to the equipment. Please use the Crestron Power
Calculator to help calculate how much power is needed for the system.
http://www.crestron.com/dealer-tech_resources/power_calculator.asp
NOTE: When installing network wiring, refer to the latest revision of the wiring
diagram(s) appropriate for your specific system configuration, available from the
Downloads | Product Manuals | Wiring Diagrams section of the Crestron website
(
www.crestron.com ).
When calculating the wire gauge for a particular Cresnet run, the length of the run
and the power factor of each network unit to be connected must be taken into