Network Poll Accelerator
Crestron
C2N-NPA8
ACT
This LED illuminates when there is communication (activity) at the LAN port with
an Ethernet network.
ERR
This LED illuminates when an error condition is detected. This may be the result of
hardware or software failure, or a programming error. To determine the actual error
condition, examine the message available through the Viewport menu
Functions | 2-Series | Error Log | Show Error Log.
Refer to the note on page 22
for a definition of Viewport.
Compatible Control Systems
The C2N-NPA8 is compatible with several Crestron 2-series control systems.
However, not all of the 2-series products are compatible with the C2N-NPA8. The
following table lists 2-series control systems (that are currently available as of this
writing) that are compatible with the C2N-NPA8 as well as the communication
methods that can be used.
Processor Compatibility
PROCESSOR SERIAL ETHERNET
AV2 YES
1
YES
4
C2N-DVP4DI
NO
YES
CNX-DVP4 NO
YES
CP2
YES
3
NO
CP2E YES
3
YES
MC2E
YES
3
YES
MC2W YES
3
NO
MP2
YES
3
NO
MP2E YES
3
YES
PAC2
NO
YES
4
PRO2 YES
1
YES
4
QM-RMC
NO
NO
QM-RMCRX NO NO
RACK2
NO
YES
4
1.
COM ports C through F are poll accelerator-ready
2.
COM ports A through C are poll accelerator-ready
3.
COM ports A and B are poll accelerator-ready
4.
Requires installation of C2ENET-1 or C2ENET-2 Ethernet card.
NOTE:
Control systems cannot use a plug in serial card (i.e. a C2COM-3) to
communicate with the C2N-NPA8.
6
•
Network Poll Accelerator: C2N-NPA8
Operations Guide – DOC. 6087A
