1
quickstart guide
C2N(I)-AMP-4X100
www.crestron.com
888.273.7876
201.767.3400
Specifications subject to
change without notice.
C2N(I)-AMP-4X100
For Regulatory Compliance information, refer to the latest version
of Doc. 7289.
QUICKSTART DOC. 7288B (2032394, Sheet 1 of 2) 04.13
4 Room Audio System
1
Make the necessary connections as called out in the diagram below. Connect power last.
Hardware Hookup
NOTE:
For triple the power (into 8
Ω
speakers only),
SPEAKER OUTPUTS
1
and 2 or
SPEAKER OUTPUTS
3 and 4 can be bridged. For example, the left
speaker’s + and - terminals are connected to the two + terminals of output #1
and the right speaker’s + and - terminals are connected to the two + terminals
of output #2. Refer to the diagram to the right.
To adjust volume when bridged, select
ROOM
1 for
SPEAKER OUTPUTS
1
and 2 or select
ROOM
2 for
SPEAKER OUTPUTS
3 and 4.
RM 1
RM 3
RM 2
RM 4
BRIDGE
8 OHMS ONLY
+
-
+
-
L +
-
+
- R
L +
-
+
- R
To Cresnet Devices
NET
From AC Power Line
PWR
Tie to Ground
G
From Unbalanced Stereo Line Level Audio
Outputs from Source Devices
ANALOG SOURCES (IN)
To Additional Amplifiers
ANALOG SOURCES (OUT)
NOTE:
The 24 volt lines on the
NET
ports of the amplifier are
limited to 300 mA.
To Loudspeakers
SPEAKER OUTPUTS
NON-BRIDGE
L +
-
+
- R
+
- +
-
LEFT RIGHT
NOTE:
The C2NI-AMP-4X100 (International
version) requires a power cord that is
harmonized to the country’s national and local
electrical codes. Each inner wire in the cord
should be at least 18 AWG (0.75 mm
2
) and rated
for at least 300 V. The temperature rating of the
cord should be at least 60º C. The cord length
should be 1.5 - 2 meters.
To Cresnet
®
Devices
LOOP THRU
2
Attach the Labels
Use the included labels and inserts to prepare the C2N(I)-AMP-4X100:
1.
Locate the
SOURCE
and
ROOM
label inserts included with the unit (
SOURCE
insert has space for six labels,
ROOM
insert has room for four labels).
2.
Apply the peel-and-stick labels in the appropriate positions on the inserts, being careful to match label positions to what is configured in the programming software. For neatest appearance, when applying a label,
cover the white guidelines on the insert. First and last labels cover one line each; labels in between cover lines on their left and right sides.
