Crestron
APAD
Wall Mount LCD Controller
NOTE:
If it becomes necessary to remove the APAD from the mounting surface,
the original mounting brackets may fall into the wall and will have to be replaced.
Additional brackets are available in the optional Wall Mount Kit – Bracket, Model
Number WMKB-1000L.
1. Pull the bezel away from the APAD.
2. Loosen and remove the two screws that secure the top of the APAD to the
mounting surface.
3. Loosen but do not remove the two screws that secure the bottom of the
APAD to the mounting surface, and shift the APAD in the hole so the
brackets will fall away from their top position on the mounting surface.
4. Pull the top portion of the APAD away from the mounting surface first and
attempt to remove the unit from the opening with the brackets hanging from
the bottom mounting screws.
5. If necessary, secure the attached cable before disconnecting it from the back
of the APAD, to keep it from falling into the wall.
Hardware Hookup
NOTE:
To prevent overheating, do not operate this product in an area that exceeds
the environmental temperature range listed in the specifications table. Consideration
must be given if installed in a closed or multi-unit rack assembly, inside a closed
desk, or in a closed podium since the operating ambient temperature of these
environments may be greater than the room ambient. Contact with thermal insulating
materials should be avoided on all sides of the unit.
Connecting the Device
Make the necessary connections as called out in the illustration that follows this
paragraph. Refer to “Network Wiring” on page 7 before attaching the 4-position
terminal block connector (supplied). Apply power to the network after all
connections have been made.
Hardware Connections for the APAD
Operations & Installation Guide – DOC. 6455
Wall Mount LCD Controller: APAD
•
11