8x8 DigitalMedia™ Switcher
Crestron
DM-MD8X8
Changes made on the front panel are made only after the
ENTER
button is
pressed. If you do not press
ENTER
, the connection is not made.
Only one input can be routed at a time. Pressing a different input button will
lose any routing plans that were not confirmed by pressing the
ENTER
button.
NOTE:
If
ENTER
has not been pressed, you can go back and “undo”
changes made to the current routing.
5.
Repeat for any other routes to be changed.
Switch Audio, Video & USB
Separately
1.
Press the
AUDIO
,
VIDEO
, or
USB
buttons to select the audio, video, or
USB portions to be switched. The respective LEDS will light.
NOTE:
When audio is switched independently, the signal is 2-channel
audio.
2.
Press the button corresponding to the input to be switched. The LED of the
selected input will light.
To turn off an output, deselect the input. The display will show “IN None”
and the input LEDs will be extinguished.
3.
Press the button(s) corresponding to the output(s) to be switched. The
LED(s) of the selected output(s) will light.
If a button press will result in changing the current routing, the LEDs of the
newly selected outputs will flash and the display will state “Press
ENTER
to Route”.
4.
Press
ENTER
to make the connection(s) shown on the front panel.
Changes made on the front panel are made only after the
ENTER
button is
pressed. If you do not press
ENTER
, the connection is not made.
Only one input can be routed at a time. Pressing a different input button will
lose any routing plans that were not confirmed by pressing the
ENTER
button.
NOTE:
If
ENTER
has not been pressed, you can go back and “undo”
changes made to the current routing.
5.
Repeat for any other routes to be changed.
View
Mode
Use the
View
Mode to view routing information for inputs and outputs. To select the
View
mode, press the
VIEW
button.
View Source Routing
•
Press an input signal button to display all of the outputs that are connected
to it.
•
Press
AUDIO
,
VIDEO
, or
USB
to see where the audio, video, or USB
portions of an input signal are routed.
View Output Routing
•
Press an output signal button to display the input signal that is connected.
All outputs that are receiving the same input signal are also displayed.
•
Press
AUDIO
,
VIDEO
, or
USB
to see the input that is providing the audio,
video, or USB portions of the output signal.
54
•
8x8 DigitalMedia™ Switcher: DM-MD8X8
Operations Guide – DOC. 6755A
