Creo Trendsetter 3244+ AL, Operator'S Manual

Page: 64 / 134

50 Chapter 3 – Maintenance
The replacement filter can be obtained from Creo Products Inc. See
Appendix A, Part Numbers for details on replacement part numbers.
To replace the debris removal cabinet filter:
1.
Turn the output device off using the power switch.
2.
Open the top of the cabinet by lifting the handle at the front.
3.
Open the top fully then let it down slightly until the support strut
locks to hold the top open.
Figure 29: Debris Removal cabinet
4.
Undo the four snap latches around the top edge of the canister inside
the cabinet.
5.
Use the two handles on top to lift the lid of the canister. Lift slowly to
avoid stirring up carbon dust.
You may have to tug to break the seal.
6.
Rest the attached lid against the top of the cabinet.
7.
Slowly pull the filter out by the handle on top.
Use your other hand to support the filter as you remove it from the
canister.
8.
Place the used filter in a suitable plastic garbage bag.
No special waste disposal procedure is required for the used filter.