Creo Trendsetter 3244+ AL, Operator'S Manual

Page: 22 / 134

8 Chapter 1 – System Overview
Unload Table
The unload table is an exit point for media. Imaged plates are ejected onto
the table. Once a plate is fully ejected, the unload table lowers to a
horizontal position.
Figure 3: Unload table (raised position)
Load light
When flashing, this light indicates:
•
the output device is ready to accept media for
imaging
•
the output device is waiting for an operator to
unload media
•
the output device is otherwise busy
During manual operation, the device cannot accept
another plate until the imaged media in the device is
unloaded, and the Load light comes back on.
Start button
During manual operation, this button initiates
medium loading and imaging.
CAUTION: Be careful to keep your hands and fingers away from the unload
table when the unload table is lowering to a horizontal position or raising to an
upright position. A warning beeper sounds before the unload table moves up or
down.
Load table
lights
Safety panels