Creo Trendsetter 3244+ AL, Operator'S Manual

Page: 21 / 134

Trendsetter 3244+ AL Components 7
Configure the output device for manual feed operations by first opening
the operator door, opening the manual bypass panel, and then closing the
operator door (see Figure 13 on page 24).
Operator Interface
The operator interface indicates the status of the output device. When a
light on the operator interface blinks, it means the output device is
performing a task or is ready to perform a task. When a light is lit, the
interface conveys only the status of the output device.
Figure 2: Operator interface
Error light This light indicates an error has occurred. It will go
out when the error condition is resolved.
The workstation will display specific information
about the error. See
Error Reporting on page 15 for
details.
Sometimes an unrecoverable system error occurs,
for example, cable faults, power supply failures, loss
of air pressure, etc. See
Recovering From a Suspend
Condition in Chapter for more information.
Imaging light When flashing, this light indicates that the output
device is imaging media.
During manual operation, the device cannot accept
another plate until the imaged media in the device is
unloaded, and the Load light comes back on.
Start button
Error light
Imaging
light
Load light