Creo Dolev 4press V, User Manual

Page: 83 / 121

Alignment Point on the Imagesetter 67
Alignment Point on the Imagesetter
During installation, the service engineer defines up to four (4) punch
systems (according to your requirements). A punch system is a set of
parameters.
The following parameters are specified by the punch system:
•
The type of punch used (up to 9 side punches or 1 head punch)
•
The number of holes (1 to 8 for the head punch and/or 1 for the side
punch)
•
The shapes, dimensions, and distances of the punches.
In addition, the service engineer specifies the coordinates of a pivot for
each punch system. This point is used as the alignment point on the
imagesetter.
Each punch system is assigned a unique name.