Creo Dolev 4press V, User Manual

Page: 76 / 121

60 Chapter 2 – Handling Cassettes and Media
Ø
Press the soft button below
Done
to open the drawer, or the one below
Cancel
to abort the request.
Detectors Status . .
- Select this entry to display a window that lists the
names of the detectors, and indicates which are active (Yes) and which are
inactive (No). The Detectors Status window appears.
Ø
To exit to the previous screen, press the soft button that is first on the
left.
Start Up !
- Select this entry to load the imagesetter’s software, starting
from StartUp stage #7 (that is, the hardware boards are not reloaded).
For additional information on Start Up see Chapter 1, Introduction to the
Imagesetter, Starting Up on page 20.
Film Rewind
- Use this option when Change Media mode is not successful
or film is stuck on the drum.
Ø
Open load drawer, then select this option. The motors rewind the film
to the load cassette.
Drawer will be open. [Done/Cancel]
Note: When relevant (for example, during Expose), the system prompts:
Process is not available .
Drum Input Output Cassette
Input Cas. Mounted Yes Film in Out. Cas. mouth No
Loading Drw. Closed Yes Out. Cas. Axis Ready Yes
Film at Film In Yes Out. Cas. Mounted Yes
Drum Output Unloading Drw. Closed Yes
Film at Film Out No General
Cutter at Right No Output to Cassette Yes
Cutter at Left Yes
InLine
Punch Installed No
Output to Processor No
Conveyor is Empty No Carriage at Home Yes
Processor is Ready No Carriage at End No