Creo Dolev 4press V, User Manual

Page: 60 / 121

44 Chapter 2 – Handling Cassettes and Media
To set the left flange:
1.
To adjust the flange, press on its inner part, and move it to the
appropriate position (see Chapter 2, Handling Cassettes and Media,
Attaching the right flange on page 45).
2.
When the flange is at the desired position, release its inner part to lock
it into position. Attempt to move the flange slightly to ensure that it is
locked in position.
Handling the Right Flange
The right flange should be situated according to the width of the film.
To set the right flange:
1.
Press on the inner part of the right flange and move it until it is
detached from the spool.
2.
Insert the spool into the film roll so that the roll rests on the inner part
of the left flange.
3.
Attach the right flange to the opposite side of the spool.
4.
Press on the inner part of the right flange and move it to the film
width groove nearest to the edge of the film roll (see Chapter 2,
Handling Cassettes and Media, Left film flange on film spool (situated
for no side punches) on page 43).
Note: Make sure to update the Media Position parameter accordingly (see
Updating the Media Info Table on page 51).