Creo Dolev 4press V, User Manual

Page: 12 / 121

x Using This Guide
This Guide Includes
The Dolev 4press imagesetter is operated from a Host workstation. This
guide describes the imagesetter and some procedures performed via the
workstation.
The guide includes the following chapters:
Chapter 1
, Introduction to the imagesetter, introduces the imagesetter,
explains how to start it up, shut it down, and use the control panel.
The last section of this chapter lists the specifications of the imagesetter.
Chapter 2
, Handling Cassettes & Media, discusses topics related to loading
and unloading of film.
The first section explains how to remove the loading cassette, load film into
it, place it back in the imagesetter, and trim the film.
The following section explains how to place the unloading/accumulating
cassette in the imagesetter, and update the Media Info table.
The next section describes the exposure process, and the actions that may
be taken during it.
The last part of the chapter explains how to remove the unloading/
accumulating cassette, and process the film.
Chapter 3
, Aligning to Punch, explains how to align images to any point on
the imageable area on film (that is, not just according to the punch holes).
Chapter 4
, Calibration and Service Utilities, explains how to guarantee
high quality exposures using a unique laser intensity for each plotting
resolution.
In addition, the functions available in Service Utilities mode are listed.
Chapter 5
, Media Related Troubleshooting, explains how to solve problems
related to the exposure media, and especially how to clear film that is stuck
in the imagesetter.
For related documents, see Dolev 4press V/V
2
Installation Guide, 399Z2G647D
.