background image

The  LR24

TM

  architectural  LED  troffer  is  for  non-insulated 

ceiling applications using 2’ x 2’ t-bar ceiling grid only.
Designed for use in 120V~277V, 50-60 Hertz  protected circuit 

(fuse box, circuit breakers) and supply wire (18AWG, stranded, 

600V, 90°C rated). SELV equivalent control gear.

      CAUTION: Risk of Electric Shock

Dry  location  use  only.  Access  above  ceiling  required.  Do 

not  install  insulation  within  76  mm  (3  in)  of  any  part  of  the 

luminaire. Suitable for suspended ceilings.

IMPORTANT SAFETY INFORMATION

Maximum case temperature is 51c at 25c ambient.

Read all instructions before installation.

Before installing this fixture or doing any maintenance, make sure 

to turn off the power supply at the circuit breaker or fuse box.
Check  to  make  sure  that  all  fixture  connections  have  been 

properly made and the fixture is grounded to avoid potential 

electrical shocks.
Do  not  handle  energized  fixture  when  hands  are  wet,  when 

standing on wet or damp surfaces, or in water.

INSTALLATION INSTRUCTIONS

LR24

TM

STEP 1: 

Carefully unpack the LR24 from its’ shipping containers. In-

spect product for defects due to shipping. 

STEP 2: 

Place the LR24 into the 2’ x 2’ T bar ceiling panel 

(see figure 1). Assembly should fit tight and not need fasteners.

STEP 3: 

Make sure that the orientation of the sheet metal assembly 

junction box (see “B” on Figure 1) faces an accessible panel to 

install the input power.

STEP 4: 

Remove junction box door (see “A” on Figure 2).

STEP 5: 

Using a screwdriver blade, remove appropriate knockout from 

junction box door to route input conduit.

TO INSTALL:

STEP 6: 

Connect wires as shown in wiring diagram (Figure 3). Push all 

wires back into the junction box.

STEP 7: 

Replace junction box door and tighten screw to secure.

CONNECTING/DISCONNECTING POWER TO LR24

 

STEP 8: 

To connect power to the light engine, align the GU24 connector 

whip “E”(see Fig 4) with the GU24 pins “F” on the light engine.

STEP 9: 

Push the connector completely over the pins and rotate the  

whip clockwise until locked (see Fig 5).

FIGURE 2

FIGURE 1

!

Reviews: