Document:
Date:
Created By:
INSTALLATION INSTRUCTIONS
C-WP-A-FCT3 Series
LPN00487X0001A0_A
03-22-2017
TMT
http://lighting.cree.com/warranty | 866.924.3645
CAUTIONS
IMPORTANT SAFEGUARDS
When using electrical equipment, basic safety
precautions should always be followed including the
following:
READ AND FOLLOW ALL
SAFETY INSTRUCTIONS
1. DANGER
- Risk of shock- Disconnect power before
installation.
DANGER
– Risque de choc – Couper l’alimentation
avant l’installation.
2. This luminaire must be installed in accordance with the
NEC or your local electrical code. If you are not familiar
with these codes and requirements, consult a qualified
electrician.
Ce produit doit être installé conformément à NEC ou votre
code électrique local. Si vous n’êtes pas familier avec ces
codes et ces exigences, veuillez contacter un électricien
qualifié.
3. Mount as down-light only.
Lumiere vers le bas seulement.
4.
Do not recess the fixture.
5. Conduit holes must be sealed with conduit plugs.
6.
Seal the fixture mounting surface with high quality
waterproof silicone sealant.
7.
For supply wire temperature rating, refer to fixture label
SAVE THESE INSTRUCTIONS
FOR FUTURE REFERENCE
FIGURE 1
1.
Remove the two screws securing the Mounting Box to the fixture.
See
Figure 1
.
NOTE:
Do not remove lens frame from the luminaire.
2.
Position the Mounting Box over the junction box, see
Figure 2,
and remove the appropriate mounting screw and wire-way knock-
outs in the back of Mounting Box to match the junction box. Apply
waterproof silicone to mounting surface.
3.
Route supply wires through the wire-way and secure the fixture
Mounting Box to the junction box with junction box screws. See
FIGURE 2.
4.
Locate the hook inside of the mounting box (See
Figure 2
) and
pull it down. The fixture can be hung on the hook while electrical
connections are made.
5.
Complete the wiring to the incoming power and ground (see
Electrical Connections). Remove the fixture from the hook and
reposition the hook back inside the mounting box.
MOUNTING TO JUNCTION BOX
FIGURE 2
6.
Slide the fixture over the mounting box ensuring all wires are
within the mounting box and secure the fixture with the two screws
removed in Step 1.
1.
Remove the two screws securing the Mounting Box to the fixture.
See
Figure 1.
2. Remove the appropriate mounting screw knock-outs and apply
water proof silicone on mounting surface. Secure Mounting Box
to the mounting surface using customer supplied mechanical
fasteners.
3.
Locate the hook inside of the mounting box (See
Figure 2
) and
pull it down. The fixture can be hung on the hook while electrical
connections are made.
4. Remove the conduit plug from the direction you intend to feed
conduit and attach customer supplied conduit, using a sealing
compound at threads.
5.
Complete the wiring to the incoming power and ground (see
Electrical Connections
). Remove the fixture from the hook and
reposition the hook back inside the mounting box.
6.
Slide the fixture over the mounting box ensuring all wires are
within the mounting box and secure the fixture with the two screws
removed in Step 1
DIRECT MOUNTING USING CONDUIT
