1 of 3
CI316X01R4_B
THE EDGE
®
LED AREA DIRECT MOUNT
Includes: ARE-EDG-DA, ARE-EDG-DL, ARE-EDR-DA and ARE-EDR-DL
INSTALLATION INSTRUCTIONS
TO INSTALL:
MOUNTING
STEP 1:
Use dimensions on template shown in
Figure 2
for drilling if pole is not
pre-drilled. (Template not to scale.)
STEP 2:
Insert Backing Plate with pre-assembled bolt through the top mounting
hole. See
Figure 1.
STEP 3:
Place gasket over bolt extending from pole. See
Figure 1.
STEP 4:
Place the top hole of the Universal mounting arm over the top bolt from
the pole and secure with lock washer and 5/16” hex nut.
STEP 5:
Install remaining bolt with lock-washer thru the bottom hole and thread
into the Universal mounting arm. See
Figure 1.
STEP 6:
Torque 5/16” hex nut and bolt to 132 in. lbs. (15 N•m).
Install fixture by sliding the fixture arm into the slot in the Universal
mounting arm. See
Figure 1
.
Fixture Arm
Mounting Clip
Universal Mount Arm
5/16-18
SS Nut
Foam Gasket
Mounting Plate
5/16-18 SS Bolt
Threaded Thru Plate
5/16-18 SS Bolt
5/16 Lock Washer
Thru Hole
Threaded Hole
5/16 Lock Washer
1
2
Fixture Arm
IMPORTANT SAFEGUARDS
When using electrical equipment, basic safety precautions should always be followed
including the following:
READ AND FOLLOW ALL SAFETY
INSTRUCTIONS
1. DANGER
- Risk of shock- Disconnect power before installation.
DANGER
– Risque de choc – Couper l’alimentation avant l’installation.
2. This luminaire must be installed in accordance with the NEC or your local electrical
code. If you are not familiar with these codes and requirements, consult a qualified
electrician.
Ce produit doit être installé conformément à NEC ou votre code électrique local.
Si vous n’êtes pas familier avec ces codes et ces exigences, veuillez contacter un
électricien qualifié.
3.
When handling, hold fixture on sides to prevent damage to the top screen or LED’s
4.
Take care to keep the LED lenses clean during installation.
SAVE THESE INSTRUCTIONS FOR FUTURE
REFERENCE
• Prior to installation, store luminaire in a dry location protected from rain, dust, and outdoor environment. If equipped with a photocell receptacle,
remove the protective cover only if immediately replacing with a suitable photocell, shorting cap, or other compatible device. The protective socket
cover is not intended to remain in place after installation. Do NOT leave receptacle open to environmental elements. Luminaires with a top-
mounted photocell receptacle should not be installed in an up-light position or at a tilt greater than 45 degrees from the down-light position.
