background image

Cadiant

 Experience 

Dynamic Skylight

Includes: Cadiant™ Luminaires

1 of 3

LPN00647X0001A0_D

INSTALLATION INSTRUCTIONS

INSTRUCTIONS D’INSTALLATION

TO INSTALL:

1

IMPORTANT SAFEGUARDS

When using electrical equipment, basic safety precautions should always be 

followed including the following:

READ AND FOLLOW ALL SAFETY 

INSTRUCTIONS

1.  DANGER

- Risk of shock- Disconnect power before installation.

DANGER

 – Risque de choc – Couper l’alimentation avant l’installation.

2.  This luminaire must be installed in accordance with the NEC or your local 

electrical code. If you are not familiar with these codes and requirements, 

consult a qualified electrician. 

Ce produit doit être installé conformément à NEC ou votre code électrique 

local. Si vous n’êtes pas familier avec ces codes et ces exigences, 

veuillez contacter un électricien qualifié.

3.  Access above ceiling required. Do not install insulation within 3 inches (76 

mm) of any part of the luminaire. Suitable for suspended ceilings.

Acces requis au-dessus du plafond. Ne pas mettre l’isolant a moins de 76 

mm (3 po) de toute partie du luminaire. Convient aux plafonds suspendus.

4.  Suitable for damp locations.

Convient aux emplacements humide.

5.  Do not use this equipment for other than its intended use

6.  Do not use outdoors

7.  Do not handle energized module with wet hands or when standing on wet or 

damp surfaces, or in water.

SAVE THESE INSTRUCTIONS FOR 

FUTURE REFERENCE

IMPORTANT NOTES:

•  Do not screw any 

additional screws into 

the side or top of the 

luminaire.

•  Do not put pressure 

on or hold by the 

interior sidewalls. 

This may damage the 

optic. See 

Figure 1.

 

•  Do not push on top of 

the center lens. See 

Figure 1.

•  Do not lay the 

luminaire on the 

sensor on the front 

face. See 

Figure 2.

•  The Cadiant™ Dynamic Skylight  

is for non-insulated ceiling 

applications using T-bar ceiling 

grid or in drywall applications only 

when mounted on Cree Drywall 

Grid Adapter DGA-22. 

•  Designed for use in  

120-277VAC protected circuits 

(fuse box, circuit breaker). Supply 

wire sized in accordance with 

national and local electrical wiring 

codes rated 90C or higher 

Do NOT Handle Interior 

Sidewalls

Do NOT Touch 

Center Lens

CORRECT HANDLING

IMPROPER HANDLING- 

SIDEWALLS

IMPROPER HANDLING-  

CENTER LENS

Handle the Cadiant™ 

Dynamic Skylight Here  

Reviews: