Workstation
Monitor
Checker
User’s Guide
Credence Technologies, Inc.
Model CTE701A
Credence Technologies, Inc.
3601-A Caldwell Dr.
Soquel, CA 95073 U.S.A.
Tel. 831-459-7488 FAX 831-427-3513
www.credencetech.com
© 2006 Credence Technologies, Inc.
Ground Masteris registered trademark
of Credence Technologies, Inc.
Patent Pending. Made in U.S.A.
PUB01907
Limited Warranty
Credence Technologies, Inc. warrants Worskstation Monitor Checker to be free from defects in materials and
workmanship under normal use and service for a period of one (1) year from date of purchase directly from
Credence Technologies, Inc., or from its authorized distributors. This warranty extends only to the original
purchaser. This warranty shall not apply to any product or part of it which has been subjected to misuse,
neglect, accident or abnormal conditions of operation. Except to the extent precluded by applicable state
law, Credence Technologies will have no liability for any consequential, incidental, or special damages.
In the event of failure of a product covered by this warranty, Credence Technologies, Inc. will repair a
product returned to authorized distributor or, only if it was purchased directly from Credence Technologies,
Inc., to the manufacturer; provided the warrantorís examination discloses to the company’s satisfaction
that the product was defective and is qualified for to a warranty claim. Credence Technologies may, at its
option, replace the product or its components with new or factory-refurbished parts or as whole in lieu of
repair. With regard to a product returned within one year of its purchase, said repair or replacement will
be made without charge. If the failure has been caused by misuse, neglect, accident or abnormal
conditions of operation, repairs will be billed at a nominal cost. Warranty does not cover transportation
costs.
Procedure
q
Follow instructions in Basics
Basics
Basics
Basics
Basics section
q
Connect 3.5mm test cable to both the Checker and to Operator jack of
your monitor.
q
Depress and keep pressed the “Wriststrap” button. Your monitor should
indicate good connection.
q
While keeping Pass button, depress and keep pressed Body Voltage
“High” button.
q
Your monitor should provide indication of excessive body voltage in
each polarity -- positive and negative. If you ordered Checker for WS Aware
with a single terminal for both operators (model CTC061-D), please see
special addendum. When Body Voltage Low button is depressed, no Body
Voltage indication should be present in the monitor.
electronic components distributor